Keyboard Case KBD75RGB Hot-swap PCB

thingiverse

This model is a keyboard case that was created for the KBD75RGB hot-swap PCB. It consists of the left and right side, which are held together by an additional center piece. To connect the two parts to the center piece, I used 8 M3X4X5 inserts with matching M3x8 screws. To secure the PCB to the case, I used 8 smaller M2X2.5X3.2 inserts in combination with M2x8 screws. The recesses for these inserts are machined into the model. To provide some damping, I used several rubber O-rings as washers for the screws mentioned.When printing, I have achieved the best results with a vertical positioning to minimize the contact surface and eliminate the need for support.