Key Condenser

thingiverse

Printing Instructions & Parts List: Small plates with space for M3 nuts have holes that can be tapped by M3 screws. These 14mm screws hold four keys in place. To set up the part in your slicer, duplicate it and mirror it about the X-axis. This ensures you have two opposite sides that can be screwed together. The parts should be short enough to print one object at a time on most printers, resulting in better quality prints with less post-processing required. Use 80-100% infill to slow down degradation, as these plates will be subject to various stresses and strains when carried in a pocket or purse. Assembly Instructions: First, screw an M3 screw through one side into the hole of the largest hexagon until its tip is just short of the width of four keys from the inside surface. Place the keys on the screw and then attach the other printed plate. Screw the top screw holding the keys' heads in place first while tightening the keys together. The keys should have some resistance to stay in place when carried. Next, screw in the remaining screws and tighten as needed.