Keurig module holder

cults3d

Yes, there are a million holders. But they either are too small, too large, take forever to print, don't fit my kitchen, etc. This is one that I did in Onshape that is stackable, and takes a shorter time to print. Need to stack two or three, use one of each. Need to stack more, simpky print as many as you need. Space on the back for double back tape. I used support for the bottom section, for the small cutout only. I have made them in PLA and PETG. Since there is nothing heavy, and shouldn't be too hot in a kitchen, PLA worked fine. As I am writing this the wife suggested making a cap for the top, to keep out dust. Didn't think that was an issue, but I will include one shortly. UPDATE: Added a cap, loose fitting, that should work well.