KEL-TEC RDB Grip Plug

thingiverse

Grip Plug for Kel-Tec RDB. The design is intentionally hollow for elasticity, infill % will not make a difference. MUST PRINT ON SIDE WITH TAB OPENINGS FACING UP. ORIENTATION SHOWN IN ATTACHED PHOTOS OF PART IN SLICER. For this design to work, orientation is critical to allow part to flex properly. Print on side with supports on the build plate only as shown. Note: Some filing/trimming required. Since this part is going into a clamshell injection molded part, I oversized the design so the end user can trim to fit as required. Even so, modifications should be minimal. Smoothing of the grip itself may also be required for flush fit.