KEF LSX Desktop speaker stand (15 degree incline)

thingiverse

Hey there, I didn't want to spend $120 on a pair of speaker stands, so I decided to print them instead for about $1.50! Remixed DoMeASolid's desktop speaker stands. Cut off the rear support bit at the back and changed the angle of incline to 15 degrees. Fits my pair of KEF LSX speakers wonderfully, aiming the tweeters directly at my ears when I'm seated at my desk (I'm 169cm height, if that helps!) to give that soundstage and real-life feel :) Printed at 10% infill, in generic Black PLA. Haven't found a reason to increase the infill, 10% should be good if you're using the same speakers as I am! Tip: place the speakers on some isolating material, like the foam I've used in the pictures. This will isolate the speakers and prevent your desk from creating unwanted resonances. (Please don't sell this design online.)