Kawasaki Ninja Cup Holder

thingiverse

This is a bracket and cup holder for a 2021 Kawasaki Ninja 650. The cup holder portion is held in place by a locking retainer tab, and can be easily removed when not in use. The bracket is bolted into place using the stock bolt holes under the rear seat (which are intended for the top case bracket mount). Spacers are included in the file to allow fastening of the bracket to the recessed bolt holes. The longer spacer goes toward the back of the motorcycle. Remove the plastic caps over the bolt holes on the motorcycle, and use 2 M8x30L bolts to screw the bracket in. The flat side of the bracket should face up. To use the mount, slide the cup holder into the hole in the bracket (the hole is keyed to the retaining tab). When the retaining tab clears the back of the bracket, rotate the cup holder until the retaining tab locks into place between the "ears" on the back of the bracket. To release the tab, press up on the movable "ear" - this will allow you to rotate the cup holder until the tab aligns with the hole cutout and you can slide out the cup holder. The bracket part stays on the bike. After printing the parts you will probably have to clean out the bracket hole, and maybe also the cup holder tab and shaft so the parts slide together easily. You should test fit the parts for correct operation before mounting it on your motorcycle. The bracket can go on either the left or right side of the motorcyle, whichever you prefer. The cup holder is different between L and R, though, due to the mounting angle of the bracket.