Kawasaki EX250 Ninja Turn Signal Bracket

thingiverse

This is a direct replacement for Kawasaki 23051-1199, the front left turn signal mounting bracket. If you require the right side (23051-1200) mirror the STL in your slicer software. I employed adaptive layer heights, which necessitated smaller layers on the "top" surface to ensure a smooth print, but this proved unnecessary for the rest of the print. Supports are essential, yet may be restricted to only over the bed and up to 45 degrees. Verify that your slicer does not place supports deep within the main bolt holes. I printed mine using Atomic Deep Black PETG. Note: The OpenSCAD file takes an excessively long time to render; utilize a command line like this to render it (the defaults allow for faster editing): openscad -DSMOOTH1=12 -DSMOOTH2=8 ninja-lh-turn-bracket.scad -o ninja-lh-turn-bracket.stl The OpenSCAD file necessitates files from https://www.thingiverse.com/thing:2358974 (smooth_edges) and https://www.thingiverse.com/thing:1484333 (geodesic sphere). Update: I had uploaded the STL without all the rendered feathering; this has been rectified.