katobu mag

cults3d

Nerf blaster katana style magazine. Prints super tidy with very little supports, only around the lips as you can seen on the picture, so almost no finishing is needed. Using the most optimized print orientation for the least amount of friction. Holds up to 17 half length / stefan darts. Closed design, very sturdy Works with katana springs, drum springs and monkee mods springs. Springs are now held in place firmly by the springlock pieces. No slipping off the follower, no locked up mags. Use 1mm wire to connect the top parts of the side pieces. Use 4 short nerf style screws or 2 long ones, or just put some 15mm wood screws through there. Print two springlock "DS" parts if you want to use drum springs, or one springlock part for normal springs. Contains changes to the side pieces made by Zack Freedman (https://www.thingiverse.com/zackfreedman/about/), so drum springs hold up by themselves now in a neat way and backwards mag releases are supported too. [21.02.19] Updated follower and side piece courtesy of Woody7070 (https://www.thingiverse.com/Woody7070/about/) to allow some more clearance for drum springs and make the whole thing operate even smoother. Go print one - Pecker time!