Karabas Nano case (small ZX Spectrum clone)

thingiverse

Karabas Nano: https://github.com/andykarpov/karabas-nano Based on rev.C. Later revisions differ in some details and may be incompatible with this design. Photos are actually from the first iteration of the process. It was intended to be changed in-place with Dremel and lighter for the best fit and measured then, however, after this I had never printed the updated version. So it is possibly (likely?) not ideal too. It is still recommended to verify all the dimensions (Fusion 360 source is included). Assembly instructions: 1. Print the keyboard svg and laminate it with lamination paper or tape. 2. Hot glue the keyboard to the board, make sure that it is aligned correctly and all buttons may be pressed 3. Put the board into the case. Adjust (dremel/wire cutters/lighter) height of stands if required. 4. Put the cover and hot glue in to the basic case.