Kanto Pokemon Badges

thingiverse

I printed these models at a higher resolution for easier post-processing because I used some plasto model putty to fill in layer lines and smooth out the surface easily. Then, I simply poured some enamel paint on top and let it drip off so there would be no brush marks. Some details still need to be painted on a few pieces, but they're about 90% done. All of these models were designed using Fusion 360, and then some were smoothed out in Meshmixer. I used 3mm thick, 8mm diameter magnets for these prints, and I found that most fit flush with just a little bit of force, without needing any glue. However, this may vary depending on the individual printer being used.