KangerTech Subox Mini Grip Case Sleeve

thingiverse

A sleeve / case / grip I designed specifically for the KangerTech Subox Mini, probably not compatible with the very latest version since my model is only a couple of years old as of 2017. This design should print without any supports required, using a layer height of 0.2mm and printing two shells/perimeters. If you can set the layer start point to the middle/rear of the case, I designed in a nice ridge that will hide the seam and make the rest of the body smooth. The sleeve fits perfectly around the Subox Mini due to an interference fit but is easy to remove when it's time to change batteries. I assume few people use the charging port so I've not made a cut-out for this. Revision 1 was the original design. Revision 2 reduced the number of Kangertech logo slats by half since printing these small bridging regions often resulted in a messy print. This version looks more like the actual Subox Mini logo with fewer slats. Revision 3 redesigned the logo cut-out completely to make the case easier to print - an unobstructed cut-out with optimized bridging region results in a nicer finish. Additionally, wall thickness was reduced to allow for printing with two shells and no infill at 0.4mm per perimeter. Note: The file provided in this Thingi will always be the latest revision.