KALLAX MMU Filament System

prusaprinters

<ul><li>Spool holders use 608 bearings</li><li>Use an M8 screw 32cm approx. measure your setup</li><li>Spool holders use M3 heat inserts to attach feet, as suggested on the start, middle, and end pieces</li><li>Foots use an M3 screw</li><li>Drill templates to attach spool holders (start and end ones) to KALLAX walls</li><li>Umbilical top use M3 heart inserts</li><li>Umbilical bottom use magnets 10x5 with M4 hole (https://amzn.eu/d/eJPtjzp)</li><li>Umbilical filament joiner use magnets 10x5 with M4 hole, assure attraction with umbilical bottom ones, and ECAS04 to handle PTFE tubes</li><li>Umbilical filament joiner visualizer to be printed by filament type/color to identify it</li><li>Skadis PTFE Guide/Retainer uses M3 screws and heat inserts</li><li>Umbilical Table version uses magnets 10x5 with M4 holes</li></ul>