Kaiterra Sensedge Mini Stand

cults3d

I got my Kaiterra Sensedge mini connected by ethernet and i couldn't lay it flat or mount it on the wall as the port is on the bac. So i made a stand to hold it vertically with a cut out at the back for the ethernet cable. You can fit the round wall mounting bracket on the stand and the unit will snap on. You can off course use this stand if you're using it over wifi too, definitely better then leaving it on its back on a shelf! Simple print with 1 bridge where you can use supports or if your printer is relatively well tuned you can just let it bridge it. There is two versions: 1) Using brass inserts for the round bracket mount. For this you will need M4x6x5 brass inserts for 3d printing which you can set using a soldering iron 2) You can screw directly into the plastic using M4 screw. As the Sensedge Mini is light this should be fine but don't over tighten the screw as you may strip the plastic What you'll need: The round mounting bracket included with your Sensedge mini 3x M4x10mm Countersunk machine screws(including head) 3x M4x6x5 Brass inserts(only if you print that one) Printed in PLA, PETG, ASA, ABS will all work well If you found this model useful you can send me a tip in $PLANETS or $ALGO to the address in instructions. Thank & Keep watching the planet!