Kabelspulenhalter - "Wire Spool Holder"

thingiverse

The next steps are approaching quickly - two crucial components still need to be completed: the left side holder and the initial section of the axle. In addition to the three-dimensionally printed parts, several essential items are required, including a 42x20x12mm ball bearing (outer diameter, inner diameter, width), an M5 threaded rod, a mounting disc, a wing nut, and a self-locking nut. A 2mm autogenous welding wire or steel wire is also needed for the electrical connections. Six fastening screws and a piece of wood are not to be overlooked. The motor holder was designed specifically for the "Multiplex Permax 400" (left over from model building). This motor operates on 6V, but 1.5V will suffice. Using a 3.6 Ohm resistor with approximately 10 watts allows the use of 5V handheld chargers. Unfortunately, the locking mechanism and spool receptacle must be printed with support...