K8200 Z-axis support + handle

thingiverse

I made a few revisions to sam-whocare's design. This one uses much less plastic and is quite strong enough. It's also a little looser on tolerance: If you're printing this, it's probably because your printer isn't as precise as it could be, so there's a little more wriggle-room here. Just add nuts and bolts! Extra mini-accessory: A little wheel for easily raising and lowering your extruder. Very handy when cleaning it. Fits over the stock nut. Instructions Make sure you're configured for lots of top layers to keep that upper slope structurally sound. Suggested improvement: Extra tab on the inside to make it easier to get those nuts in! It can be done without, but it's very fiddly. I had to use a bit of broken filament to poke them upwards from below and hold them in place while I got the bolts in.