K8200 E3D Titan Extruder Mount and Fan

thingiverse

I designed a mount and fitted it with an E3D Titan Extruder, a V6 Hot End, and a Fan Mount for three-point cooling. The mount is based on the design from thingiverse by o_liviu, but I elongated it to fully hold the motor and added a push fit for the fan duct. The fan duct was inspired by desiquintans' research that shows combining point and area cooling provides the best solution. Therefore, I created a duct with three air routes: half of the output is directed at the Hot End Tip, then a quarter to each arm. Each arm is separate and has a push fit into the body for several reasons: they can be replaced independently, I am free to modify the design, and they are easier to print. Do not try to print this with any nozzle wider than 0.4mm as the duct walls are super thin to get the most from the single fan. See the complete rebuild at thingiverse's 2079048 for further information. Also, see a dual fan version at thingiverse's 2170127.