K8200/3DRAG Z axis stepper mount (rework of http://www.thingiverse.com/thing:232446)

thingiverse

I will rewrite this text. When printing the original Z-endstop mount, I damaged its attachment bracket while attempting to remove the support material, which led me to create a separate microswitch holder for gluing. This setup proved satisfactory; however, I discovered that the stock part provided limited reinforcement behind the screw holes, causing them to become loose upon tightening. To resolve this issue, I redesigned the mounting area on the printer so the shaft is positioned more reliably near the motor mount. Furthermore, I encountered a minor misalignment with the microswitch during assembly. Consequently, I added a small spacers component specifically for this Z-axis part because the straight wall of its base does not fit properly with the screw attachment point as intended. Ultimately, adjusting the angle of the microswitch holder slightly to compensate for this misalignment could result in better structural alignment between components.