K7XX mic attachment

thingiverse

Updated to a newer version here: https://www.thingiverse.com/thing:2894679 This model (V1) is easier/quicker to print and lightweight, but the joint tends to loosen over time. _______________________________________________________________________ A mic arm add-on for K7XX (should also work with some other models) with several degrees of movement. Requires 3 or 2 M2 screws and possibly nuts. (2 Screw needed if upward hinge is not used, 6mm M2 if no nut is required, and 8mm M2 if a nut is needed) Please note: It will scratch the plastic where the clip holds onto the headphone. You might be able to avoid this by printing it smaller and breaking away the inner side of the clip before clipping it on, but that will not provide maximum security. This add-on works on either side of the headphone. I suggest placing it on the side with the headset wires and twisting the mic wire with the headphone wire so you don't have two loose wires hanging down. Quick tip: Buy cable sleeve and tidy up both cables; see pic.