Jumpin Game

pinshape

Another 3M Bookshelf Game Series Pawn Jumping Game Addition The expansive game board is nearly the maximum printable area of the Replicator 2. Instructions I printed the entire board in one piece on a glass plate coated with hairspray, achieving a thickness of .34mm. This necessitates flawless tramming of the build plate to prevent warping at the ends. After several attempts, I finally achieved success, but if I were to redo it, I would likely use a raft instead. I've included the STL files for both the single-piece and multi-colored options. Given the limited surface area in contact with the build plate, a raft is almost essential. To avoid a melted mess on top, I strongly advise against printing one piece at a time. It's crucial to allow sufficient cooling time between layers. My print resolution was set to .2mm.