Jumper T16 pro v2 Hall + 433mhz shield
thingiverse
Jumper T16 Pro V2 Hall sensor shield for 433mhz radios. Tested with 433T30D 433mhz 1W modules featuring QLRS technology. Stock radio struggles with these modules, picking up excessive noise on gimbal lines. Lowest power settings are plagued by a lot of noise, while full power triggers the 'emergency mode' in just 3 to 5 seconds. Shielding only the back cover of the radio helps minimize noise but still leaves room for improvement. This mod effectively reduces noise by 99%, and results can be seen here: https://www.youtube.com/watch?v=gBWRGof567Y To install the shield, it must be soldered to the ground, a process that can be observed here or accomplished through personal preference. Proceed with this modification at your own risk.
With this file you will be able to print Jumper T16 pro v2 Hall + 433mhz shield with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Jumper T16 pro v2 Hall + 433mhz shield.