Jumper T-lite Balanced Neck Strap Holder

thingiverse

There was published couple of neck strap holders here, but no one passed my requirements. Therefore I designed my own construction. The design is for those, who do not use external module (which is probably most of users). The holder does not cover any important part of transmitter, you can watch display as well as use trim buttons without problems. For transport, it can be simple wrapped to transmitter. The holder is made from two parts, connected by single M3 screw. No nut is used, its role adapts the back part of holder. The base part is intentionally designed as prestressed, to prevent bending out from radio. There is necessary to push it hard to radio when mounting the four screws into back radio panel. Print both parts in designed position. Support for lever is possible, but not necessary.