Jumper 260+ quad conversion parts, New arms, FPV transmitter holder, Sony CCD camera conversion + misc

thingiverse

The brand new arms are engineered to hold the ESC with just friction and a small dot of hot glue (no zip ties required!) they also have an expected failure point (by design) at the posts to avoid transferring a hard impact onto the mainboard, built in 28mm motor guards that provide extra protection. Note: These arms will also work perfectly with LittleBee 20amp ESCs as they are the same width as the stock BHHeli long 20amp ESCs with the jumper quad. The new tilt mount securely holds the super popular Sony CCD camera, designed to cradle the board as much as possible since the jumper frame provides no protection to the camera. Captures a standard nylon lock nut inside the case to tighten the camera on the pivot points precisely. Cone legs and antenna brackets are thoroughly tested but no reason they won't work seamlessly. Several mounting positions for the cone legs, screw them in, you could thread right into the plastic or drill out for brass thread inserts if you prefer. All of my parts use M3 machine screws and nuts, so you will need to drill out any of the mounting holes used with a 3mm bit or tap it with a 3mm tap to mount these parts easily. Note about weight increase: With arms, transmitter bracket, Sony CCD plus printed mount and receiver, it's 405g, about 65 grams heavier than the kit with original pieces and no receiver. The 28mm motors with 6" props have zero issues with that. Side note about transmitter and camera connections: Do yourself a favor and rip those junk ports off the board and replace them with servo leads if you haven't already. Print Settings: Printer Brand: RepRap Printer: Prusa i3 Supports: No Resolution: 0.3 Infill: 30 Notes: 30% infill 3 perimeters on all components was the way I printed it