Joytech EVIC Sleeve

thingiverse

A custom-made sleeve designed specifically for your Joytech EVIC vaporizer. Print Settings Printer: Prusa Mendel I3 Rafts: No Supports: No Resolution: 0.3 mm Infill: 20% dense Post-Printing Break it in Carefully. The fitted sleeve might be too tight until you have taken the unit in and out several times. To safely remove your Joytech EVIC if it is too tight, use a screwdriver or push rod to gently push the unit out from below while holding the case firmly in place. You may need to apply some extra force, similar to a hammer tap, if it is very stubborn. After taking it out a few times, it will fit smoothly. I Designed This Custom Sleeve This custom-made sleeve was created using Google Sketchup. The biggest challenge I faced during design was accommodating the slope from bottom to top of the surface.