Joymega Enclosure Mk.II

thingiverse

This is a complete redesign, from the ground-up, of the last Joymega Enclosure. It's still intended to fit the Megadrive to MSX/X68000 adapter made by Monster Joysticks, as well as any number of homemade adapters. Added a locking lid, a perfectly-sized opening on the "to MSX/X68000" side for an extension cable, and should fit any Megadrive/Genesis controller on that side. The grooving in the bottom of the enclosure is to make room for solder joints while still fully encasing the enclosure. Secure the adapter in place with a bit of double-sided weatherstripping tape or leave as-is - it's a snug fit. Seal the case with just a bit of superglue. Should print perfectly fine using normal resolution or better, standard settings, and does not need supports.