Joycon Single Controller

thingiverse

Human: 2540% SCALE!!! (sorry for modeling in inches) UPDATE: Check out the V6 in the files. Small adjustments were made to the hands and a boost of strength was added in certain directions. These changes are minor enough that if you already have my previous model printed, it's not worth wasting plastic on an update, but they're worth printing if you're planning on making more. My settings: I printed at 0.5mm layer height, 1mm nozzle, PLA, and used three perimeters with no infill. The print took 2.5 hours at a speed of 40mm/s. (Thanks Volcano!) I rotated the model 12 degrees about the x-axis to minimize support material. Comments: Fit is tight but acceptable with my settings. If it's too tight for your taste, sand down the gentle grade on the bottom face of the controller. NOT compatible with the shoulder buttons/strap. I tried all other switch controllers on Thingiverse and none felt right AND fit the controller well. So, I made my own. This one fits my hands nicely, holds the Joycon tight, is RIGID, and uses minimal plastic while still being a full-size controller. Feel free to remix! This is my first upload to Thingiverse, feedback is appreciated.