jjrc h6c prototype frame 3

thingiverse

Most likely my final iteration of this frame for the jjrc h6c.This frame was built for peak performance. Main frame sliced in cura, 0.2 layer height, 16 percent infill, .4 height for top and bottom layers (+/- affects screw hole rigidity). Other parts printed at 50-100 percent infill with precision. No raft or supports needed if printed in the right orientation. Main frame has its rigidity focused on the x-axis, also z with stepped surface i-beam design, while lower frame and i-beam brace are in the y-axis. Foot is .8mm thick for reduced weight optimization. Mbrace part can be used in place of lower cambrace part, for detaching camera for reduced weight efficiency. Added the camera mount seamlessly. Take care not to bend the flat flex connector as these are extremely delicate components. Board can be tricky to insert into cage, and should only be inserted in one orientation (from the top), then the frame bent a bit to snap it in gently. Edit: Experiencing rolling shutter effect with the camera mount unfortunately. Not sure how to eliminate this issue completely, perhaps printing the frame with less or different infill percentage will give a different resonant point to get it out of sync with camera fps, also camera fps increases as the aperture reduces. Only getting rse with small aperture in bright conditions consistently.