Jinx Zapper Blaster

prusaprinters

<p>The original version can be found <a href="https://www.thingiverse.com/thing:5158745">here</a>. This version changes some proportions and adds a few details to be closer to reference material from the show.&nbsp;</p><p>This version uses printable pins for part alignment. The smaller pin is used for the hole in the top rail to index the barrel better.</p><p>The infill is up to you to determine how heavy the blaster is and where it is balanced. However, it is recommended that the barrel is not printed below 15% infill to help resist warping if using a heat gun later to speed along paint drying.</p><p>I printed everything using the .2mm layer height with Overture PETG using the Prusament PETG .2mm speed profile.</p><p>For gluing up I used E6000 for the first time. This worked well enough but in places where I missed cleaning small oozing areas, they became rubbery blobs that were annoying to clean off later.&nbsp;</p>