Jinx 180 v2

pinshape

I was blown away by the original Jinx design, it looked stunning for a TinkerCAD creation. But I wanted to give it a complete overhaul and transform it into a sleek monocoque chassis using 123D Design. I took the basic framework dimensions and completely revamped them, integrating ESCs directly into the arms and creating numerous cutouts for wiring, antennas, and other essentials. Everything was completely new. The setup features high-performance 2204 motors, DYS SN16 ESCs, and runs on four powerful 4.5-inch Tri-blade Bullnose DAL props. The Naze32 rev 6 flight controller is paired with an Eachine camera and vTx for a seamless flying experience. The arms are secured to the chassis with M3 x 25mm countersinks, while M3 nuts are permanently installed in the lower deck. Finally, No. 4 self-tappers hold the decks firmly in place against the skirt.