jig v1 small model

cults3d

jig using 4 colours. For the "phosmini" piece, phosphorescent is recommended. this lure for cephalopod fishing is inspired by the needle jig lure version 1 ("slim"), but smaller : https://cults3d.com/en/3d-model/various/leurre-pour-turlutte-aiguille-v1-slim For this version, you have to tinker a little more. You can get it: flexible shaft method, for mounting on line body, with lead after lure; more for vertical fishing: little sleeves, -steel bottom of the line adapted to the "sleeves", rigid axle method, for gallows mounting, throwing and pulling : -stainless steel wire (I took 0.8mm) And, whatever method you choose; -baskets for jigs. -broken rings -soft, if possible phosphorescent beads. -heat-shrink tubing (optional) you need, as tools: -a flat clip or two -lighter or glue gun or repair resin -a broken ring pliers (very practical to avoid getting angry when passing these rings) -a big needle, or escher needle, makes it easier. (see pictures) If you have difficulty to pass a piece of pla, to melt with a lighter, to block the baskets on the twisted stainless steel wire : (Because the diameter of the PLA would be too large) Heat the PLA a first time and stretch it a little on itself to obtain a finer filament.