JHEMCU RuiBet 1-2S LiPo Charger 2507 Fan Mod
thingiverse
I noticed the JHEMCU RuiBet 1-2S LiPo charger runs a bit warm so I designed this fan mod to provide active cooling. You will need a 5v 2507 fan to create this. Print in PETG or PLA Instructions: - Remove the bottom plate of the JHEMCU charger. This will be discarded and replaced with "Side A". - Mount 2507 fan on to "Side A" using 4x 10mm M2 screws and secure with 4x M2 nuts - Feed the fan power wires through center hole and solder to 5v/gnd pads on the charger's USB port (you will need to trim away some of the outer USB I/O shielding to make it easier to solder directly to the pads) - Mount "Side A" onto JHEMCU charger base using 6x 5mm M2 screws - Mount "Side B" onto "Side A" using 4x 5mm M2 screws I opted to use a stepdown regulator and run the fan at 3.3v for a more quiet operation
With this file you will be able to print JHEMCU RuiBet 1-2S LiPo Charger 2507 Fan Mod with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on JHEMCU RuiBet 1-2S LiPo Charger 2507 Fan Mod.