Jhead Mount to Ubis Hotend Adapter

thingiverse

I required use of printrbot's ubis hotend with jhead mount (for Smartrapcore). Unfortunately, the grooves are not alike between two devices. A fun fact: smartrapcore's bracket is nearer to a groovemount than a genuine J-head. I have updated STLs accordingly. Please feel free to adapt yours by using SCAD. SCAD source at Github: https://github.com/lordofhyphens/jheadtoubis Instructions: Print 2 copies, then install them on ubis and afterwards install assembly where it expects a J-Head. The bowden are pre-set for 3mm OD tube with nut trap. Change SCAD and remake STLs if you need something different. The pushfit model should allow to thread M6 pushfit connector into the top after its bolt is close.