JGAurora A5/A3S E3D V6 adaptation

thingiverse

24/02/2019 Upgrade New piece, carriage without support for V6, to adapt it to other extruders, cyclops or similar type that can be anchored with 2 screws. You only have to make the holes for the screws according to the model. Replacement of the rear part of the printer carriage JGAurora A5 / A3S to adapt the E3D V6, as well as piece of attachment of the same and coupling of fan of layer. An attempt has been made to make the piece and the coupling as close as possible to the original, in order to lose as little space as possible of the printing surface. You have to modify the values of the bed in marlin and the values of leveling in the configuration of the tft screen. This is version 1 and I hope that the community helps to improve it, but we can say that at the moment the piece is fully functional and it has lost approximately 1 cm of printing surface in X and Y, because the design of JGAurora A5 / A3S by the chassis does not allow to go further. I'll update as the pieces get better.