JGAURORA A3S Modeling platform easy leveling mount kit

thingiverse

I think JGAURORA A3S is very nice but it has a few issues for me. The main problem was the difficulty of turning the knobs that adjust the height of the modeling stage, which caused pain in my fingertips. Additionally, the knob on the back right side where the filament reel is located was hard to turn. So I made parts by A3S and updated A3S to solve this issue. This updated A3S is working fine so far, and the printing results are good, but I'd like to try various printing models for a while longer. If I don't like the results, I will put the A3S back in its original style. If you want to print, here's what you need: Print <Upper Left.stl> as is: 1 Invert and print <Upper Left.stl>: 2 Print <Upper Parts(with Cable guide).stl> as is: 1 Print <Bottom parts.stl> as is: 2 Invert and print <Bottom parts.stl>: 2 To install these, you'll need the following screws and others: For Upper parts: M3 15mm - Countersunk screws: 4 M3 15mm - Nuts: 4 M3 15mm - Washer: 4 For Bottom parts: M4 40mm - Hexagon bolt screws: 4 M4 40mm - Nuts: 4 M4 40mm - Washers: 8 The four springs are replacing the original ones.