JG MP5 SD6 Silencer Tracer Insert

cults3d

Tracer insert for JG Mp5 SD6 Silencer. Modification to silencer required. The front cap it glued on and to remove i used hot water to loosen the glue and then twisted it off, next came the brutal part in my case as i chipped and snapped the plate under the front cap out of the silencer. once this is done pull both metal weights out of the silencer and the plastic middle was the snapped to the base where the metal weights where seated. The lower seats for the metal weights are needed for the insert to sit on so please be careful not to damage them. once this modification is done smooth the inner of the silencer as the insert is a tight fit and will require pushing to the bottom of the silencer. The tracer i used is a swiss arms mini pistol tracer and drops in the insert and is slack enough to be tipped out for operation and charging. The cap of the insert will require gluing to the original silencer cap and when inserted clamps the tracer in place. 2 x 3mm screws are required for maximum security of the cap...2 holes will need to be drilled in the silencer to line up with the insert cap side holes.