JG AURORA Z-603S - X STEPPER SUPPORT

thingiverse

Updating my old JGAURORA Z-603S. Use this little support to stabilise the X-stepper. You will also need: 2 x Screws M3 - 30 mm 2 x Screws M3 - 20 mm 2 x M3 locking nuts (the housing diag = 6,3 mm) 4 x washers You will find the regular support (marine blue), and a "short" version (salmon). This bracket has deeper screw holes (2 mm). Use this second one if you have the feeling your carriage runs into the chassis when homing. With the regular bracket, you should have 1,5 mm "air" before hitting the Y-Stepper. The NEMAs on my Z-603S run hot during the first 15 min, so my advice is NOT to print this support in PLA. I'm comfortable with ABS, but you can go for PETG if you are more familiar using this filament. If printing ABS, you need to enlarge the STL in your slicer before generating your gcode. Remember ABS shrinks. I’m actually using no name ABS and scaled to 100,7%. And finally, there is two STLs. One is named "NORMAL" and a second one is "CHAMFER" (0,5 mm). Use at your convenience. NOTE I: you will probably need to sand the support before placing it between the 8 mm guide and the stepper. This is OK, it won’t be much. Use fine sandpaper. NOTE II: after around 10 hours printing, unmount and check the support. Then mount again for better fitting. Have fun! O. JG AURORA Z603-S - X STEPPER SUPPORT JG AURORA Z603S - X STEPPER SUPPORT JGAURORA Z603-S - X STEPPER SUPPORT JGAURORA Z603S - X STEPPER SUPPORT