Jewelry Holder

cults3d

This is a jewelry stand/holder made to hold and show rings, necklaces, earrings and bracelets. It comes in 5 different parts: - A bottom support made for the rings - A support for the bracelet rod that need to be strong - A bracelet rod to hold the bracelet - A necklace holder that holds both necklaces and earrings (support and brim are recommended for this piece) - A hook (you need 8 pieces) to hold the necklaces Depending of the printer you might need to cut the edges of the holes a little bit. You will only need a scalpel to cut some of the edges and super glue Assembly: - Glue the bracelet Rod to its support - Make sure that the notch can enter the hole of the bottom support - Put a line of glue on top of the notch on the bracelet rod support for extra stability (not compulsory) - Put each hook into the necklace holder (you might need to use the scalpel here) - Make sure that the notch of the necklace support can enter the hole of the bottom support