Jet_Engine_compressor_stadeg

thingiverse

Human: 3 missing files added This is based on the Turbo-jet engine of MiG 15 MOTOR GT2820/6 The British IWM-CH14832A Gloster that flew on May 15, 1941 This custom jet engine compressor stage has been tested to +60,000 rpm Out-runner motor and a 100-Amp hobby-wing driver running at 44 volts and 33 amps have shown promising results Ran for 45 seconds at 50% throttle before having to stop due to excessive motor heating Vibration levels were found to be acceptable If you're planning to run high-speed tests on 3D printed jet engines, a good shrapnel cage is essential to prevent catastrophic failures Two pictures of the turbo fan blade are not from this project but serve as a warning about the dangers of testing prototypes A recent failure resulted in the hub parting with the blade and flying 10 meters forward, clipping a brazing rod on the workbench Parts were scattered up to 50 meters from the contact zone