Jellybean X2 Beta 1

thingiverse

Beware, this is Beta 1 only - it has not been fully tested yet. If you decide to make one, please share your feedback so we can learn and improve. This is a brand-new version of the Jellybean X. Its innovative design allows for all electronics to be assembled outdoors and dropped in from the top, making it easy to swap out if something breaks. The top part simply sits in place and can be secured with clear tape, adding extra strength and rigidity to the entire quad. To print this new version, we recommend using ABS plastic and enhancing its durability with Acetone vapour treatment. Don't forget to include supports and a thorough cleanup for the lid during the printing process. When it comes to electronics, choose Cicada BLHeli-S escs that are no wider than 12mm. Opt for 3-inch racecraft props and pair them with high-performance 1306 red bottom 4000kv motors. For a sleek setup, use a small vtx, rx, and camera - we recommend the CCD 1000TVL from multirotor shop. Select 4S 500mah or smaller batteries to power your Jellybean X.