Jeep TJ Roll bar Dashcam Mount

prusaprinters

After upgrading to a newer dashcam, I wanted the ability to use my older dashcam (Viofo A119) for rear-view recording, but with a Soft Top, rear-view windshield mounting is impractical.To get the Dashcam to stick to the mount (like you would on a windshield), I affixed the clear windshield mounting sticker (provided by Viofo) to the flat of the 3D printed mount with 15 minute epoxy. I then used the 3M Tape/Sticker (provided by Viofo) to affix the GPS Dashcam mount to the windshield sticker (like you would if sticking directly to a windshield).I printed mine with PLA and haven't had any problems, but you may want to use PETG or other higher temperature filament if you expect high interior vehicle temperatures.I used Zip ties to attach the mount to the roll bar.I designed this to work on a 2005 Jeep Wrangler with factory padded roll bar. This should work with any TJ model (with padded roll bar). Just in case though, I recommend cutting a small test slice/piece off the model in your slicer program before printing the entire model to make sure the diameter fits correctly).Printed with:-PLA-15% infill-Print on side (Default orientation)-Supports required