Jeep Headlight Receptacle

thingiverse

This is my revised version of part Chrysler 5012685AA which is where the ball joints on the rear of 1999-2004 Jeep Grand Cherokee Headlights fit into place, helping the headlight stay secure while allowing the housing to work seamlessly with the angle adjustment screw. I used three on each side and printing all three worked out great. However, in hindsight, I think I anticipated a bit more shrinkage than what actually occurred. So if anyone else prints and uses these parts, try printing slightly smaller, perhaps 1-2% smaller. The main question I now have is whether or not printing these parts in PLA will allow the part to misshape due to engine and environmental heat.