Jeep Cherokee KL Cargo Management System Right

prusaprinters

This part will allow you to move the Off-Road Accessory Kit over to the right side where it fits perfectly into the alcove where there are two bag hangers. This gets it out of the way of the main cargo area. (see pictures) This was designed for the 2017 Jeep Cherokee (KL) Trailhawk without the subwoofer. I believe this option removes the alcove. Any other year of Cherokee wasn't tested and I am not sure it will fit as designed. It was designed so no adhesives or modifications were needed. It just slips into place and tucks up under the overlapping plastic panel. So far after a few weeks of use I have seen no issues. Its nice to have it out of the cargo area, but still visible and available. Installation is simple. Align the bottom tabs to the left of the bag hooks and push the bottom into the hooks until you can fit the top up into the upper plastic panel. Then slide the whole thing to the right and guide the tabs into the bag hooks. UPDATED: Added tabs to the bottom to help it fit the bag holder clips tighter. Print Settings Printer Brand: SeeMeCNC Printer: Rostock Max v3.2 Rafts: No Supports: Yes Infill: 15 Filament: Inland (MicroCenter) PLA+ Notes: Part needs an area of 210mm x 100mm. Supports are needed inside the handle area. How I Designed This =================== Still using 123D... I started with a cardboard template that I cut to a rough size, but it gave me the correct measurements. I used 123D because I am too lazy to learn something else. It took 4 attempts to get the design right. Each version I only printed the first few layers to be able to hold it up to the spot in the car and make markings for further changes. Above is version 5 where I added the "Trailhawk" logo. Category: Automotive