jbperf Dual VR Conditioner Board V2.1 Enclosure

thingiverse

Note: This was modeled in inches, so you may have to scale it to 2540%. I struggled to find anything that looked halfway decent to hold my Dual VR board when converting my Miata from a cable speedo to a VR input from a 2004 Miata's electronic speed sensor. This has a mounting hole meant for a 6mm stud and requires no tools to hold the board in. The lid snaps in place and I've been able to remove it by gently prying the edges up with a tiny flat head screwdriver. It's obviously not waterproof, but it's better than flopping in the breeze, and some sealant around the top after everything is verified functional would keep moisture out if this needs to be in a hostile environment. I printed this with PETG but ABS would work as well I'm sure. PLA is generally not advised in an automotive environment due to temperatures, but would work if you're using this for something else. The connector cutouts work with the JST-XH type connectors used on 3-cell lithium R/C battery balance leads.