JBL Clip 3 zip-tie Mount

prusaprinters

<p>This is a zip tie assisted bike mount for the JBL Clip 3.<br/> Currently works on bikes with a flat top tube, will probably upgrade later to fit common round top tubes.</p> <p>Demo video - <a href="https://youtu.be/nCgbRD90aPQ">https://youtu.be/nCgbRD90aPQ</a></p> <p>Works great as a general-purpose mount for the clip 3 as you can zip tie it to anything.</p> <p>Inspired by this video from Reddit - <a href="https://www.reddit.com/r/functionalprint/comments/h8szg1/snapfit_speaker_mount_with_extra_layer_of/">https://www.reddit.com/r/functionalprint/comments/h8szg1/snapfit\_speaker\_mount\_with\_extra\_layer\_of/</a></p> <p>Couldn't find the file anywhere, OP didn't share it in the comments, so I went and made my own.</p> <p>Supports are recommended, at an angle of 33 degrees.</p> <p>I use support blockers in Cura in order to make sure there are no supports on the zip tie and button holes, although it is usually not a problem removing these supports.</p> <p>Managed to print it on a stock Ender-3 without supports at 0.3 layer height and speed of 100 mm/s, but for the best results, supports are recommended.</p> <p>Currently, the zip tie holes are very thin at the bottom (around 1mm). It does hold on, but I will make them thicker for a more fail-proof design.</p> <p>**The model exports 90 degrees sideways, I now rotate it in the slicer until I will find the reason...</p> <p>*EDIT: F3D file now available, sorry it took so long</p> <h3> Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Creality</p> <p><p class="detail-setting printer"><strong>Printer: </strong> <div><p>Ender 3</p></div><strong>Rafts:</strong></p> <p>No</p> <p><p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p></div><strong>Resolution:</strong></p> <p>0.15-0.2</p> <p><p class="detail-setting infill"><strong>Infill: </strong> <div><p>100%</p></div><br/> <strong>Filament:</strong><br/> Generic PLA Green</p> </p></p></p> Category: Sport &amp; Outdoors