JBL Clip 3 zip-tie Mount

thingiverse

This is a zip tie assisted bike mount for the JBL Clip 3. Currently works on bikes with a flat top tube, will probably upgrade later to fit common round top tubes. Demo video - https://youtu.be/nCgbRD90aPQ Works great as a general-purpose mount for the clip 3 as you can zip tie it to anything. Inspired by this video from Reddit - https://www.reddit.com/r/functionalprint/comments/h8szg1/snapfit_speaker_mount_with_extra_layer_of/ Couldn't find the file anywhere, OP didn't share it in the comments, so I went and made my own. Supports are recommended, at an angle of 33 degrees. I use support blockers in Cura in order to make sure there are no supports on the zip tie and button holes, although it is usually not a problem removing these supports. Managed to print it on a stock Ender-3 without supports at 0.3 layer height and speed of 100 mm/s, but for the best results, supports are recommended. Currently, the zip tie holes are very thin at the bottom (around 1mm). It does hold on, but I will make them thicker for a more fail-proof design. **The model exports 90 degrees sideways, I now rotate it in the slicer until I will find the reason...