JarMix Duplicator 9 Cii Inspired Cooler Remix Remix

thingiverse

I had amassed a substantial stock of 40mm fans but was still searching for an ideal 40mm fan duct that would encircle the nozzle. The warping issues on overhangs were severe enough to prompt consideration of designing and installing an E3D V6 mount, so I began seeking a duct solution that could be adapted to fit a 40mm fan while providing adequate cooling around the entire part. Upon investigation, no suitable option was found, but I came across the Remixed Duplicator 9 Cii Inspired Cooler. Recognizing its potential for modification in SketchUp, I decided to create my own custom cooler. The resulting design fits perfectly! There's minimal interference from the carriage mount, heater block, or leveling sensor, and sufficient clearance is maintained from both the sensor and the belt. My initial test prints with this fan have been outstanding. I've transitioned from experiencing warping on most overhangs to successfully printing a torture test with smooth overhangs up to 65 degrees, leaving me thoroughly pleased with my printer's performance!