Japanese Torii Gate

prusaprinters

A 4-part Japanese Torii gate General:0,2mm layer heightPrinter using PLABlack and Red colour Sizes:3 pre-generated sized available to download. Main dimensions table below: Height [mm]Width[mm]Small73110Medium117177Large161243  Printing:The black parts (Feet and top beam) are fairly simple to print. The red part (main body) might be a little tricky. The way I managed to do it is shown below:I printed it upside down with supports enabled.I added 4 manual supports tapered wider at the base (to prevent it falling over)I added a 5mm wide brim for further supportThis way I managed to print it without falling over.Removing the supports does take some time. Cutting it away piece by piece I was able to remove it. Assemble:Push the feet over the legs of the torii gate main bodyThe vertical beams are not at a perfect 90degree angle. So rotate the feet accordingly so they are flush with the surface below.Place the Top beam on top of the main bodyI did use some glue to attach them together. But it can do without