Jamma Edge Cover Pin Safe

thingiverse

The original concept was outstanding, but several individuals expressed apprehension that the plastic could harm the pin edge. I was queried as to whether there was anything I could do to minimize the risk of someone damaging the edge connector.\r\n\r\nThis revision solely grasps the jamma connector at its two sides. Consequently, your print must be incredibly precise, with the objective being to create an opening 114.4mm wide; you might need to print a test and measure it, then perform calculations to scale accordingly for your printer. A common scaling factor of 101% is often required for PLA prints like this.\r\n\r\nAll credit goes to EVAWINGZERO for his ingenious idea. Moreover, if you are printing in TPU, his design will be a better option; my update is merely suitable for hard plastics.