Jaguar XF X250 Phone Stand

thingiverse

This is a remix of johnny0stars excellent work. I wanted to try and make a stand that met the following requirements: * Lid closes with stand + charger in situ * Can be adapted to fit different phones * Doesn't lift out when removing phone with 1 hand * Charges phone when phone is in stand While talking on https://www.jaguarforums.com/forum/xf-xfr-x250-44/3d-printed-phone-holder-271839/ it was highlighted that it could work for LHD as well with a stand that was not angled towards the driver so this design is included as well, however it is untested as I live in an RHD country! I used the following charger and cable for my purposes. The charger and cable fit into the charger socket while still allowing the lid to close: Charger - AINOPE https://www.amazon.co.uk/dp/B09MFTH8T5 Cable - AAOTOKK https://www.amazon.co.uk/dp/B08CY32TRR 1. Print the stand for your car (LHD or RHD) 2. Print the arms. For RHD cars the larger arm goes on the right. For LHD cars the larger arm goes on the left. On some prints these come out as a very tight fit and some they are a little loose - once fitted to the car this doesn't matter, they don't need gluing in my experience. If you use a case on your phone, you will probably skip to step 5. The phone inserts are a tight fit to a bare handset and will not work with a case. 3. Print/adapt a phone insert for your model of phone and chosen charger cable. The included Fairphone design is a fairly generic 6.3" Android device Fit the charger cable into the phone insert and clip the 2 halves together to trap the cable in place. 4. Insert the phone insert into the stand from above - it is a *tight* fit! 5. Feed the charger cable through the gap in the stand so that it can reach the charger socket 6. Push the stand with the arms fitted into the cubby - you may have to manipulate the outer trim of the centre console to get it to fit. Video to demonstrate the fit and usage: https://youtu.be/_tl2QIBPp94