Jack Stand Pad for BMW vehicle

thingiverse

This pad is specifically designed to fit snugly into a BMW car's jacking block, allowing you to lift your vehicle safely without causing damage. It should provide a secure and tight fit. The pad can be used with standard harbor freight type jack stands that have an upward curved top section. The maximum width of this top section should not exceed 25mm (1 inch). If you require a version with a wider top section or a different curvature radius, please message me and I'll be happy to assist. To ensure stability, print the pad with at least 60% infill and 4 layers on the outer walls. Supports are not required; simply print the part as it is, with the flat side facing downwards. Please note that jacking your car up and working underneath it can be extremely hazardous and may result in serious injury or death. Always exercise caution and ensure you know what you're doing. I disclaim all responsibility for any injuries caused by using this model. If in doubt, do not use it.