JA 37 VIGGEN

thingiverse

I designed a massive model for my kids and couldn't locate a suitable one, so I discovered an adequate alternative and ran it through MakePrintables autofix. The result turned out decent but was missing a few details. I removed the landing gear from the model, leaving the weaponry intact. Notably, I scaled up the design to 80cm in length, measuring from nose to tail. To facilitate printing, I broke down the model into multiple smaller pieces. Prints turned out satisfactory. !!!!! BIG WARNING!!! This model is not FLAWLESS! Verify your slicer for unwanted holes!!! Most of the holes closed up in my slicer, but I encountered some small ones on the front wings near the rudders. The original creator of this model was Anders Lejczak. Big thanks to them! http://www.colacola.se/expo_viggen.htm